FairReplace

Gas furnace replacement cost in Philadelphia, PA

Installed, 80,000 BTU, 95%+ efficiency

Low$4,500
Typical$4,900
High$5,950

Metro area: Philadelphia-Camden-Wilmington, PA-NJ-DE-MD. Wages: BLS, May 2025. Permit notes checked October 2026.

A typical furnace (80,000 BTU, 95%+ efficiency) costs about $4,900 installed in the Philadelphia area, 1% above the national figure, because HVAC technicians here earn a median $31 an hour against $29 nationally.

Gas furnace (80,000 BTU, 95%+ efficiency), installed

Prices for: Philadelphia-Camden-Wilmington, PA-NJ-DE-MD

Low$4,500
Typical$4,900
High$5,950

Unit $1,700 (online list price, middle of 9 listings) plus installation about $3,200 for this area. Permit fees and code extras are listed below the table.

How this estimate is built

Prices by size in Philadelphia

SizeLowTypicalHighNational typical
60,000 BTU, 80% efficiency$3,700$4,150$5,400$4,100
60,000 BTU, 95%+ efficiency$4,400$4,800$5,750$4,750
80,000 BTU, 80% efficiency$3,800$4,100$5,000$4,050
80,000 BTU, 95%+ efficiency$4,500$4,900$5,950$4,850
100,000 BTU, 80% efficiency$3,950$4,300$5,450$4,250
100,000 BTU, 95%+ efficiency$4,600$5,000$6,000$4,950

Local labor: what HVAC technicians earn here

Hourly wagePhiladelphia metroUnited States
25th percentile$25$23
Median$31$29
75th percentile$38$37

The Philadelphia market

Philadelphia's Department of Licenses and Inspections requires a plumbing permit for replacement work, and water heater permits may be issued immediately when a contractor applies. Replacing appliances in a one- or two-family home qualifies for a mechanical EZ permit. Any owner or authorized agent may apply, but a licensed master plumber must oversee plumbing and a licensed contractor must perform mechanical work. A Certificate of Approval follows the required inspections, and boilers are regulated by the Pennsylvania Department of Labor and Industry. Fees run $31 for a water heater in a one- or two-family home, $69 per separately submitted mechanical appliance, a $100 filing fee credited toward the permit and small City and State surcharges. Rowhouse stock means mixed systems: EIA found 19% of Pennsylvania homes heat with a boiler and 6% heat water with oil. Camden, Wilmington and the suburban counties have separate permit offices.

Philadelphia's energy compliance process asks the field inspector to see an HVAC Equipment Certificate, so make sure your installer provides it. Furnaces are the main heat in 56% of Pennsylvania homes. In a rowhouse, ask where a high-efficiency furnace's plastic vent would exit, since side walls are often shared. Ask whether the old chimney will still serve the water heater properly once the furnace stops using it.

Permits in Philadelphia

Permit for this jobYes (mechanical permit; EZ permit for replacing appliances in 1-2 family dwellings) (source)
FeeWater heater: $31 (1-2 family) or $37; mechanical appliance submitted separately $69 each in 1-2 family ($158 otherwise); direct-vent/flue-connected heating unit $69 in 1-2 family; $100 non-refundable filing fee credited to permit fee; surcharges $3 City + $4.50 State per permit.
Who can pull itOwner or authorized agent may apply, but work must be done/overseen by a licensed master plumber (plumbing) or licensed contractor (mechanical)
InspectionYes

Rebates in Pennsylvania

HEAR: announced, not open yet. HOMES: announced, not open yet. Source: PA DEP Energy Programs Office, checked October 13, 2026.

What these programs cover, and other states

Other systems in Philadelphia

Gas furnace cost in other metros

Sources