FairReplace

Gas tankless water heater replacement cost in Dallas, TX

Installed, About 180,000–199,000 BTU (2–3+ bathrooms)

Low$2,550
Typical$2,750
High$3,700

Metro area: Dallas-Fort Worth-Arlington, TX. Wages: BLS, May 2025. Permit notes checked October 2026.

A typical tankless water heater (About 180,000–199,000 BTU (2–3+ bathrooms)) costs about $2,750 installed in the Dallas area, 2% below the national figure, because plumbers here earn a median $29 an hour against $31 nationally.

Gas tankless water heater (About 180,000–199,000 BTU (2–3+ bathrooms)), installed

Prices for: Dallas-Fort Worth-Arlington, TX

Low$2,550
Typical$2,750
High$3,700

Unit $1,566 (online list price, middle of 15 listings) plus installation about $1,200 for this area. Permit fees and code extras are listed below the table.

How this estimate is built

Prices by size in Dallas

SizeLowTypicalHighNational typical
About 150,000 BTU (1–2 bathrooms)$2,000$2,600$3,350$2,650
About 180,000–199,000 BTU (2–3+ bathrooms)$2,550$2,750$3,700$2,800

Local labor: what plumbers earn here

Hourly wageDallas metroUnited States
25th percentile$23$24
Median$29$31
75th percentile$36$41

The Dallas market

Dallas permit information online is thin and partly dated, so treat what follows as a starting point and check with the city's Building Inspection division. A City of Dallas plumbing pamphlet states that a permit is required for water heater replacement, with a $100 minimum plumbing permit fee, but it dates to 2011. No Dallas page found names furnace, AC or heat pump replacement, and inspection steps were not stated. Permits go to city-registered licensed contractors, or to a homeowner who lives in the house and holds a homestead exemption recorded by the appraisal district. Cooling sets the pace here: EIA found 83% of Texas homes use central air, and heat pumps are the main heating equipment in 19%. Fort Worth, Arlington, Plano and other cities in the metroplex each run their own permit office.

A tankless install in Dallas may move the heater from an attic platform to an exterior garage wall to shorten the vent run, which changes the gas piping. That moves the job past a like-for-like swap. Ask the plumber which gas line size the quote assumes and whether the meter can supply it. Getting the unit out of the attic also makes descaling and service far easier, which is a fair reason to pay for the move.

Permits in Dallas

We couldn't confirm all of Dallas's rules from official pages. Check with the building department before work starts.

Permit for this jobYes (source)
FeeMinimum permit fee $100 (plumbing); otherwise varies with new vs remodel and value of work. No itemized water heater or HVAC fee found.
Who can pull itCity-registered licensed contractor, or homeowner who occupies the home and holds a homestead exemption
InspectionNot stated on the city pages we checked

Rebates in Texas

HEAR: announced, not open yet. HOMES: announced, not open yet. Source: Texas State Energy Conservation Office (Comptroller), checked October 13, 2026.

What these programs cover, and other states

Other systems in Dallas

Gas tankless water heater cost in other metros

Sources